Eddy Current Testing (ET) Services in Norway 2026 — ASNT Level III Led

Why Norway generates ET demand

Norway's continental shelf remains one of the world's most advanced offshore provinces — subsea-heavy developments, floating production, Hammerfest LNG in the Arctic — supported by yards and bases along a coastline that also builds and services much of the world's advanced shipping.

Offshore MT gives way to eddy current and ACFM where coatings must stay intact — weld toes on primary structure can be examined through paint, saving the blast-and-recoat cycle.

Marine diesel engine components, turbocharger parts and shaft tapers are examined with eddy current during overhaul, where a missed crack ends up as a tow.

LNG plant exchangers and the fin-fan fleet supporting liquefaction take eddy current examination between runs, where tube failure means capacity loss on a scheduled cargo.

Condenser and feedwater heater tubing is eddy current's core power-generation work — full-bundle screening each major outage with plugging decisions made tube by tube.

What typically gets examined

In practice that means ET work across platform topsides and floating production units, subsea equipment at onshore bases, Melkøya LNG plant, ship steel at the yards, and hydro plant components — with scope set by the damage mechanisms each asset actually runs, not by a standard menu.

Certification and acceptance in Norway

NORSOK standards define offshore work, with PSA (Havtil) regulation above them; Nordtest/ISO 9712 certification is standard, and subsea and cold-climate qualification requirements make procedure demonstrations more demanding than warm-water equivalents.

Examinations themselves are performed to ASME Section V Article 8 and its tubing appendices, ISO 15548, and ASTM E243 for tube examination. The evidence chain — technician certification current on the day, instrument and reference block calibration, and the procedure revision in force — travels with every report, because that bundle is what an audit actually checks.

Working with Atlantis in Norway

Atlantis delivers eddy current testing through inspection teams mobilised to site, working under Atlantis procedures with ASNT Level III oversight — we are straightforward that this is a mobilised model rather than a walk-in local office, because for planned inspection work that is usually the better arrangement anyway: the crew, procedures and equipment arrive matched to your scope. Read the ET service overview, see how results are recorded and retrieved, or tell us about the Norway scope and we will respond with an honest view on mobilisation.

Norway scopes are quoted from the national eddy current testing service: bobbin, array and rotating-probe tube inspection plus surface examination on non-ferrous and coated components.