EN 12668 — Non-Destructive Testing — Characterization of UT Equipment
European standard for characterizing ultrasonic testing equipment — Part 1 covers instrumentation, Part 2 covers probes, Part 3 covers complete system.
Scope
EN 12668 — Non-Destructive Testing — Characterization and Verification of Ultrasonic Examination Equipment — is the European standard for verifying that UT instruments, probes (transducers), and complete systems meet specified performance characteristics. EN 12668 is a "characterization" standard — it defines the tests, parameters, and tolerances by which UT equipment is evaluated. The standard applies to manufacturer characterization of new equipment, to periodic verification by end-users, and to acceptance testing of repaired or recalibrated equipment. EN 12668 is structured as three parts: Part 1 (Instruments), Part 2 (Probes), Part 3 (Combined equipment). Current editions: EN 12668-1:2010, EN 12668-2:2010, EN 12668-3:2014. The standard is harmonized as both EN (European Norm) and BS/DIN (national adoption).
Code compliance is only demonstrable if the evidence behind it is: the procedure revision in force, the inspector's certification state and the instrument's calibration status at the time of test. Atlantis NDT provides ASNT Level III consulting for procedure and written-practice work against this code, training toward the certifications that reference it, and inspection management software that keeps that evidence recoverable years later. Request a consultation.
How a standard like this is applied in an inspection programme
A standard is only half of the requirement. It defines how an examination is performed and, in some cases, how results are classified — but the acceptance criteria that decide whether a component stays in service normally come from the construction or in-service code governing the item, not from the examination standard itself. Confusing the two is one of the more common findings in a procedure review: a procedure that correctly cites the examination standard but applies acceptance criteria from the wrong code or the wrong edition.
What has to be in place for compliance to be demonstrable
A written procedure qualified against this standard for the specific materials, thickness ranges and geometries in scope — not a generic procedure covering everything
Personnel certified for the method and level under ASNT SNT-TC-1A, ANSI/ASNT CP-189 or ISO 9712, current on the date the examination was performed
Equipment, probes and reference standards in calibration on that date, with traceability to a national standard under ISO 17025
The applicable edition of the standard recorded against the examination, so historical work stays assessed under the edition then in force
Technique sheets under the same revision control as the procedure above them — the most frequently uncontrolled document in an otherwise compliant quality system
Edition changes
When a new edition is issued, new work moves to it from a defined effective date that you set and record; work already performed stays assessed under the edition in force at the time. Retrospectively applying a new edition to historical dispositions invalidates the original acceptance decision and creates a substantially larger problem than the one being solved.
Where this usually goes wrong
Not in the technical content, but in reconstruction. An auditor picks an issued report and asks which procedure revision applied, who performed the work and whether they were qualified on that date, and whether the instrument and reference blocks were in calibration. Programmes that hold only current state can answer none of those. Binding the document revision, the qualification state and the calibration state to each inspection record as it is created turns that from an investigation into a lookup.
EN 12668 examinations are performed and evaluated by technicians qualified in the method. The UT Level 2 course covers angle-beam weld examination on flawed samples, calibration and reference sensitivity, and evaluating indications against ASME, AWS and API acceptance criteria. Completing a course is not certification: under an employer-based scheme such as SNT-TC-1A, your employer certifies you after its own examinations.
For employers:ASNT Level III consulting covers procedures, the written practice, qualification examinations and audit support for your technicians.